Using the proper cable is an important point to check, (we have seen many failures due to clients trying to reuse old 1Gb cables, which in fact where inherited with even older 100mb infrastructures.).
#Grsync centos mac
Regarding the model, Intel and Atto model are pretty popular among our clients, and for the particular case of Linux to Mac connections the "SmallTree" brand can be a good option. But we recommend to use the same model that you are using in the other side of the network. In general, most 10Gb adapters work well out of the box in Mistika workstations. For these cases, you can still activate the NetworkManager in the mConfig->MistikaRaidix panel (but we recommend to only use it for the wifi connections, and let the other wired ethernet connections configured with Raidix) And the Raidix network interface does not offer interface for wifi connections. Note: Systems with the Mistika-Raidix storage option do not have the NetworkManager activated by default. Otherwise half the signal is absorved by the workstation itself, and they are really slow an unstable. Note: Avoid wifi pen drive models that do not have an antenna, or at least an extension cable. Your phone and wifi devices should be able to connect the workstation now. If you want the opposite (to offer an Access point for your phone or other wifi devices ): In the network options of the same icon just add a "Shared Connection", select the "AP mode", and do not change anything more. If you need Internet from a wifi router, just plug it and all the wifi networks around should appear in the NetworkManager (the network icon in the linux bar) inmediately.
#Grsync centos driver
Wifi pen drives using that chipset should work straight out of the box with no need for any driver installation on CentOS 7.xxx, and they only cost a few Euros. But there is a chipset with good support for CentOS 7.xxx, that is totally plug & play: Many wifi pen drives are known to be difficult to install, and they can be slow and unstable. When using laptops it should be trivial, but adding a wireless port to a workstation is not always easy.
#Grsync centos how to
How to setup a wireless wifi network in a Mistika workstation Please note that the important names are the ones shown by executing this command in a console: (if you do not know what is the "grub" then it is better if you ontact the support guys.) If that is the case, you can solve it by adding the parameters biosdevname=0 and net.ifnames=0 to the grub launch options. Hp workstations will name network interfaces starting with "eth" as usual, but other models (laptops and other desktops) may assign "strange" interface names, that could fail to be regognized by the Mistika licensing tool. But that is not a problem for Mistika licenses, which should continue working normally.
Ethernet eth0 / eth1 mac addresses may appear swapped in comparison with Suse11. This will also propagate your name changes automatically to the /etc/hosts, batch manager, totem, and other systems in the renderfarm that will need to be aware about the hostname change. Instead, use mConfig to change the hostname (mConfig->General->Hostname. The hostname can not be changed with any of the above tools.
Wired networks, network interface names, and hostnames However, they can also activate the NetworkManager in the mConfig->Mistika-Raidix, for special purposes like using a WiF network Note: Systems with the Mistika-Raidix storage option will need to use the Raidix GUI (the MistikaStorage icon on the desktop) for the network configuration (no network icon is provided in the linux bar). It is pretty similar to any other OS, so we will only comment some differences and some tips: Preliminar Note: In CentOS 7.xxx, the network is configured trough the NetworkManager tool, which is accessed trough the network icon of the linux bar. Modified on: Sat, 22 Sep, 2018 at 7:25 PM
0 kommentar(er)
